Basic Size and MWC Input Condition for RAID Levels
This section describes the basic size for each RAID level and the input conditions for the MWC of each RAID level.
Refer to the following.
Web GUI User's Guide
Web GUI User's Guide
C140-0005-01ENZ3
- Web GUI Overview
- Volume
- Volume (Basic Information)
- Create Volume
- Delete Volume
- Rename Volume
- Format Volume
- Expand Volume
- Expand Thin Provisioning Volume
- Start RAID Migration
- Stop RAID Migration
- Stop External Volume Data Synchronization
- Set Allocation
- Optimize TPV/FTV Capacity
- Cancel Optimizing TPV/FTV Capacity
- Delete Snap Data Pool Volume
- Force Delete Snap Data Pool Volume
- Modify Thin Provisioning Volume Threshold
- Initialize Snap Data Volume
- Encrypt Volume
- Forbid Advanced Copy
- Permit Advanced Copy
- Delete External LU Information
- Change Data Reduction Processing CM
- Performance (Host I/O)
- Performance (QoS)
- Performance (Advanced Copy)
- LUN Group
- Reservation
- Pinned Data
- Bad Sector
- Balancing Thin Provisioning Volume
- Volume (Basic Information)
- RAID Group
- Thin Provisioning
- Advanced Copy
- Connectivity
- Connectivity
- Host Group
- CA Port Group
- LUN Group
- Host Response
- CA Reset Group
- Host-LU QoS
- Component
- System
- System
- Network
- Setup Network Environment
- Setup Firewall
- Setup SNMP Agent Basic Interface
- Setup SNMP Manager
- Setup SNMP Agent MIB Access View
- Setup SNMP Agent User
- Setup SNMP Agent Community
- Setup SNMP Agent Trap
- Download MIB File
- Send SNMP Trap Test
- Display SMTP Log
- Setup E-Mail Notification
- Setup Syslog
- Setup SSH Server Key
- Create Self-signed SSL Certificate
- Create Key/CSR
- Register SSL Certificate
- Setup SSL Security Configuration
- Remote Support
- Define Role
- Eco-mode
- Event/Dump
- Audit Log
- Firmware Maintenance
- Storage Migration
- External Drives
- Extreme Cache Pool
- Utility
- Reset Backup/Restore Fail
- Reset Machine Down Recovery Fail
- Force Write Back
- Clear Sense Data
- Initialize BUD
- Force Restore
- Force Restore Thin Provisioning
- Change Main CM
- Reboot All CMs
- Shutdown/Restart Storage System
- Apply Configuration
- Cancel Applying Configuration
- Backup Configuration
- Export Configuration
- Start/Stop Performance Monitoring
- Clear Cache
- System Settings
- Appendix
- User Roles and Policies
- Status List
- Glossary (A - Z)
- Factory Default List
- Detailed Information for RAID Levels, Drives, and Volumes
- Supported Functions for Each Controller Firmware Version
- Supported Functions for Each Model
- Naming Conventions of Volumes, Hosts, and External RAID Groups
- Basic Size and MWC Input Condition for RAID Levels
- Basic Size for each RAID Level
- Basic Size When Using the Default Stripe Depth Value (For Standard Type Volumes, TPVs, or SDPVs)
- Basic Size When Using the Default Stripe Depth Value (For WSVs)
- Basic Size When Stripe Depth Is Tuned (For Standard Type Volumes, TPVs, or SDPVs)
- Basic Size When Stripe Depth Is Tuned (For WSVs)
- Basic Size When Stripe Depth Is Tuned (For TPP Capacity)
- Allowed Input for MWC
- Basic Size for each RAID Level
- Using RADIUS Authentication
- Setting Procedures for Replacing HBAs
- Advance Preparation
- Overview of the Procedure
- Checking the Connection Status Between the Host and the Storage System
- Required Storage System Settings After HBA Replacement (When Host Affinity Settings are Used)
- Required Storage System Settings After HBA Replacement (When Host Affinity Settings are not Used)
