When Controlling by the Power Switch

This section explains how to use the Power switch to turn off the ETERNUS DX.

  1. Press the Power switch of the controller enclosure or the frontend enclosure for four seconds or more.

    The READY LED () on the controller enclosure or the frontend enclosure is turned off.

    Important

    • After power-off, wait for about one minute before turning power on again.

    • Press the Power switch only once. If the Power switch is pressed again between the time of the READY LED () turning off and the POWER LED () turning off, the ETERNUS DX power may turn on.

  2. The power of the ETERNUS DX is disconnected.

    When the power is disconnected, the POWER LED ( or ) of each enclosure is turned off.

Note

The following figure describes the messages that are displayed on the LCD panel and the LED state when turning off the ETERNUS DX900 S6 or the ETERNUS DX8900 S6.

Figure: LCD Panel Messages When Turning Off the ETERNUS DX