LAN Connection

The ETERNUS DX requires a LAN connection for operation management.

In addition, information such as ETERNUS DX failures is notified to the remote support center.

Note

When a single controller enclosure is used, make sure to connect from both controllers (CM#0 and CM#1) to the LAN for operation management. When two or more controller enclosures are used, make sure to connect from four or more controllers to the LAN for operation management.

Specifications for the LAN ports of the ETERNUS DX are shown below.

  • Operation Mode

    Ethernet (1000BASE-T/100BASE-TX/10BASE-T)

  • Internet Protocol

    IPv4 and IPv6 are supported.