ONTAP 9.13.1 commands

network arp show

Display static ARP entries

Availability: This command is available to cluster and Vserver administrators at the admin privilege level.

Description

The network arp show command displays static ARP entries present in a given Vserver. This command will not display dynamically learnt ARP entries in the network stack. Use the network arp active-entry show command to display dynamically learned ARP entries in the network stack.

Parameters

{ [-fields <fieldname>,…​]

Use this parameter to display only certain fields of the ARP table.

| [-instance ] }

Use this parameter to display all the fields of the ARP table.

[-vserver <vserver name>] - Vserver Name

Use this parameter to display ARP entries that are specific to a given Vserver.

[-remotehost <IP Address>] - Remote IP Address

Use this parameter to display ARP entries for the specified IP address

[-mac <MAC Address>] - MAC Address

Use this parameter to display ARP entry for the specified MAC address

[-ipspace <IPspace>] - IPspace

Use this parameter to specify the IPspace associated with the Vserver

Examples

The following example displays static ARP entries from the Vserver vs1.

cluster1::> network arp show -vserver vs1
Vserver     Remote Host       MAC Address
----------- ----------------- -----------------
vs1
            10.238.0.2        40:55:39:25:27:c1
Top of Page