SANtricity express configuration manuals ( CA08872-012 )
SANtricity express configuration
Linux express configuration
Fibre Channel Express Setup
Configure IP addresses using DHCP
Install SANtricity Storage Manager
Access SANtricity System Manager
SAS Setup
Configure IP addresses using DHCP
Install SANtricity Storage Manager
Access SANtricity System Manager
Determine SAS host identifiers
iSCSI Setup
Configure IP addresses using DHCP
Install SANtricity Storage Manager
Access SANtricity System Manager
Configure array-side networking
Configure host-side networking
iSER over InfiniBand Setup
Configure IP addresses using DHCP
Determine host port GUIDs and make the recommended settings
Install SANtricity Storage Manager
Access SANtricity System Manager
Set up the multipath.conf file
SRP over InfiniBand Setup
Configure IP addresses using DHCP
Install SANtricity Storage Manager
Access SANtricity System Manager
Configure network connections—SRP over Infiniband
NVMe over InfiniBand Setup
Configure IP addresses using DHCP
Install SANtricity Storage Manager for SMcli
Access SANtricity System Manager and use the Setup wizard
Determine host port GUIDs and make the recommended settings
Set up NVMe over InfiniBand on the host side
Configure storage array NVMe over InfiniBand connections
Discover and connect to the storage from the host
Display the volumes visible to the host
Access NVMe volumes for virtual device targets
Access NVMe volumes for physical device targets
Create filesystems (RHEL 7 and SLES 12)
Create filesystems (RHEL 8, RHEL 9, and SLES 15)
NVMe over RoCE Setup
Configure IP addresses using DHCP
Install SANtricity Storage Manager
Access SANtricity System Manager
Display volumes visible to host
Access NVMe volumes for virtual device targets
Access NVMe volumes for physical device targets
Create filesystems (RHEL 7 and SLES 12)
NVMe over Fibre Channel setup
Configure IP addresses using DHCP
Install SANtricity Storage Manager
Access SANtricity System Manager
Set up NVMe over Fibre Channel on the host side
Display the volumes visible to the host
Access NVMe volumes for virtual device targets
Access NVMe volumes for physical device targets
Create filesystems (RHEL 7 and SLES 12)
VMware express configuration
Configure IP addresses using DHCP
Configure the multipath software
Access SANtricity System Manager
Perform NVMe over FC-specific tasks
NVMe-oF Connection Guest OS Disk Configuration Procedure
Windows express configuration
Configure IP addresses using DHCP
Access SANtricity System Manager
Discover storage on the host
When you add new LUNs, you must manually rescan the associated disks to discover them. The host does not automatically discover new LUNs.
LUNs on your storage system appear as disks to the Windows host.
-
Log on as an administrator.
-
To discover the storage, run the following command from a Windows command prompt.
# echo rescan | diskpart
-
To verify the addition of new storage, run the following command.
# echo list disk | diskpart
