In a MetroCluster IP configuration that is not preconfigured at the factory, you must verify that the ha-config state of the controller and chassis components is set to “mccip” so that they boot up properly.

Before you begin

The system must be in Maintenance mode.

Steps

Display the HA state of the controller module and chassis:

ha-config show

The controller module and chassis should show the value “mccip”.
If the displayed system state of the controller is not “mccip”, set the HA state for the controller:

ha-config modify controller mccip
If the displayed system state of the chassis is not “mccip”, set the HA state for the chassis:

ha-config modify chassis mccip
Repeat these steps on each node in the MetroCluster configuration.