MetroCluster Manuals ( CA08871-401 )
Review requirements
The Tiebreaker software provides monitoring capabilities for a clustered storage environment. It also sends SNMP notifications in the event of node connectivity issues and site disasters.
The Tiebreaker software must be installed and configured.
Software requirements
You must meet the followings software requirements, depending on the version of Tiebreaker you are installing.
ONTAP Tiebreaker version |
Supported ONTAP versions |
Supported Linux versions |
Java/MariaDB requirements |
---|---|---|---|
1.5 |
ONTAP 9.8 and later |
|
With Red Hat Enterprise Linux 8.1 to 8.7:
|
1.4 |
ONTAP 9.7 |
|
With CentOS:
With Red Hat Enterprise Linux 8.1 to 8.7: *MariaDB 10.x (use the default version that is installed using "yum install mariadb-server.x86_64") *JRE 8 |
Additional requirements
You must be aware of the following additional requirements:
-
The Tiebreaker software is installed on a third site, which allows the software to distinguish between an inter-switch link (ISL) failure (when inter-site links are down) and a site failure. Your host system must meet certain requirements before you can install or upgrade the Tiebreaker software on your local computer to monitor the MetroCluster configuration.
-
You must have "root" privileges to install MetroCluster Tiebreaker software and the dependant packages.
-
You can only use one MetroCluster Tiebreaker monitor per MetroCluster configuration to avoid any conflict with multiple Tiebreaker monitors.
-
When selecting the Network Time Protocol (NTP) source for the Tiebreaker software, you must use a local NTP source. The Tiebreaker software should not use the same source as the MetroCluster sites that the Tiebreaker software monitors.
-
Disk capacity: 8 GB
-
Firewall:
-
Direct access for setting up AutoSupport messages
-
SSH (port 22/TCP), HTTPS (port 443/TCP), and ping (ICMP)
-