SANtricity 11 Manuals (CA08872-010)

to Japanese version

Workflow for mirroring a volume synchronously

You configure synchronous mirroring using the following workflow.

This feature is not available on the AB6100 or AB3100 storage system.

  1. Perform the initial configuration in Unified Manager:

    1. Select a local storage system as the source for the data transfer.

    2. Select a primary volume from the local storage system.

    3. Select a remote storage system as the destination for the data transfer, and then select a secondary volume.

    4. Select synchronization and resynchronization priorities.

    5. Begin the initial data transfer from the primary volume to the secondary volume. Depending on the volume size, this initial transfer could take several hours.

  2. Check the progress of the initial synchronization:

    1. In Unified Manager, launch SANtricity System Manager for the local array.

    2. In SANtricity System Manager, view the status of the mirroring operation. When mirroring is complete, the status of the mirrored pair is "Optimal." The two arrays attempt to stay synchronized through normal operations. Only new and changed blocks are transferred from the primary volume to the secondary volume.

  3. Optional: You can change synchronization settings in SANtricity System Manager.

    Because synchronous replication is continuous, the replication link between the two sites must provide sufficient bandwidth capabilities.

Top of Page