ONTAP 9.15.1 commands

system controller bezel-led modify

Modify the state of the bezel LED log (lit or unlit)

Availability: This command is available to cluster administrators at the admin privilege level.

Description

The system controller bezel-led modify command controls the illumination state of the LED logo on the chassis bezel (lit or unlit) of a node. On platforms where two controllers in a high-availability (HA) configuration share the same chassis, any changes to the LED logo’s illumination state are kept synchronized on both nodes.

Parameters

-node {<nodename>|local} - Node

The node whose bezel LED logo illumination state is being modified.

[-state {off|on|disconnected|unknown}] - Bezel LED Logo State

The bezel LED logo illumination state of the node. The possible values are: on (lit), off (unlit), disconnected. The default state is on .

Examples

The following example turns on the bezel LED logo:

cluster1::> system controller bezel-led modify -node node1 -state on

The following example turns off the bezel LED logo:

cluster1::> system controller bezel-led modify -node node1 -state off
Top of Page