ONTAP 9.15.1 commands

vserver nvme create

Create NVMe service configuration

Availability: This command is available to cluster and Vserver administrators at the admin privilege level.

Description

The vserver nvme create command creates an NVMe service for a Vserver.

When you create the NVMe service on a Vserver, the Vserver must have only nvme in the allowed-protocols list.

When you create the NVMe service on a Vserver, the administrative status of the service is up by default.

Parameters

-vserver <Vserver Name> - Vserver Name

Specifies the Vserver for the NVMe service.

[-status-admin {down|up}] - Administrative Status

Specifies the configured administrative status of a service.

[-mdns-service-discovery-enabled {true|false}] - Use Multicast DNS Service Discovery (privilege: advanced)

Specifies the configured mDNS service discovery status of a service. If you set this parameter to false , the Vserver will not advertise NVMe-IP LIFs over Multicast DNS. The default value is true .

Examples

cluster1::*> vserver nvme create -vserver vs_1

Creates an NVMe service on Vserver vs_1 .

Top of Page