ONTAP 9.12.1 commands

50←PDF
  • ONTAP 9.12.1 commands(CA08871-263en.pdf)
  • cluster add-node-status-clear-failed

    Remove failed nodes from the status list

    Availability: This command is available to cluster administrators at the admin privilege level.

    Description

    The cluster add-node-status-clear-failed command removes failed entries from the status list displayed by the cluster add-node-status command.

    Examples

    The following example removes failed entries:

    clus1::> cluster add-node-status
            Node Name        Cluster IP          Status              Error Reason
            ---------------- ------------------- ------------------- --------------------------
            -                2.2.2.2             failure             The cluster port MTU
                                                                     values do not match.
                                                                     Retry cluster create or
                                                                     join after updating the
                                                                     cluster port MTUs to the
                                                                     same value.
            node1            1.1.1.1             success
            2 entries were displayed.
    clus1::> cluster add-node-status-clear-failed
    clus1::> cluster add-node-status
            Node Name        Cluster IP          Status              Error Reason
            ---------------- ------------------- ------------------- --------------------------
            node1            1.1.1.1.            success
    Top of Page