ONTAP 9.12.1 commands

50←PDF
  • ONTAP 9.12.1 commands(CA08871-263en.pdf)
  • system ha interconnect ood send-diagnostic-buffer

    Send diagnostic buffer to partner

    Availability: This command is available to cluster administrators at the advanced privilege level.

    Description

    The system ha interconnect ood send-diagnostic-buffer command enables you to run a short out-of-order delivery diagnostic test. The command sends a buffer to the partner controller over the high-availability interconnect. This command is only supported on FAS2500 series nodes in the cluster.

    Parameters

    -node <nodename> - Node

    This mandatory parameter specifies which node will send the diagnostic buffer to its partner. The value "local" specifies the current node.

    Examples

    The following example demonstrates how to use this command to send a diagnostic buffer to the partner:

    cluster1::*> system ha interconnect ood send-diagnostic-buffer -node ic-f2554-03
    Top of Page