ONTAP 9.12.1 commands

50←PDF
  • ONTAP 9.12.1 commands(CA08871-263en.pdf)
  • network bgp config modify

    Modify BGP configuration

    Availability: This command is available to cluster administrators at the advanced privilege level.

    Description

    The network bgp config modify command is used to modify a node’s border gateway protocol (BGP) configuration.

    Parameters

    -node {<nodename>|local} - Node

    This parameter specifies the node on which BGP configuration will be modified.

    [-asn <integer>] - Autonomous System Number

    This parameter specifies the autonomous system number (ASN). The ASN attribute is a positive integer of the range from 1 to 4,294,967,295. It should typically be chosen from RFC6996 "Autonomous System (AS) Reservation for Private Use" or the AS number assigned to the operator’s organization.

    [-hold-time <integer>] - Hold Time

    This parameter specifies the hold time in seconds.

    [-router-id <IP Address>] - Router ID

    This parameter specifies the local router ID. The router-id value takes the form of an IPv4 address.

    Examples

    cluster1::> network bgp config modify -node node1 -router-id 1.1.1.1 -asn 20
    Top of Page