ONTAP 9.12.1 commands

50←PDF
  • ONTAP 9.12.1 commands(CA08871-263en.pdf)
  • system service-processor image modify

    Enable/Disable automatic firmware update

    Availability: This command is available to cluster administrators at the admin privilege level.

    Description

    The system service-processor image modify command enables or disables automatic firmware update on the Service Processor of specified node or nodes.

    Parameters

    -node {<nodename>|local} - Node

    The parameter specifies the node on which automatic Service Processor firmware update is to be enabled or disabled.

    [-autoupdate {true|false}] - Firmware Autoupdate

    Setting this parameter to true enables automatic firmware update. Setting this parameter to false disables automatic firmware update. This is a mandatory parameter.

    Examples

    The following command enables automatic firmware update for the Service Processor on the local node.

    cluster1::> system service-processor image modify -node local -autoupdate true

    The following command enables automatic firmware update for the Service Processors on all the nodes.

    cluster1::> system service-processor image modify -node * -autoupdate true
    2 entries were modified.
    Top of Page