ONTAP 9.12.1 commands

Name of the Vserver which needs to be migrated.

Name of the source cluster.

Runs the prechecks and tells if the Vserver migrate operation can be started or not.

Name of the IPspace in the destination cluster.

Provide the list of aggregates where the volumes will be created in the destination cluster.

This parameter specifies if the Vserver migrate operation should cutover automatically when ready. The default setting is true.

This parameter is to specify if the Vserver migrate operation should cleanup the source Vserver automatically. Setting the parameter requires diagnostic privilege. The default setting is true.

This paramater specifies the throttle value to limit the network bandwidth used for the migrate transfers. It sets the maximum rate (in Kbytes/sec) at which data can be transferred during the operation. The throttle value is applied individually to each volume of the migrating Vserver. To fully use the network bandwidth available, set the throttle value to unlimited or 0. The default setting is unlimited. The minimum throttle value is four Kbytes/sec, so if you specify a throttle value between 1 and 4, it will be treated as if you specified 4.