ONTAP 9.12.1 commands

50←PDF
  • ONTAP 9.12.1 commands(CA08871-263en.pdf)
  • system controller location-led modify

    Modify the location LED state of a controller

    Availability: This command is available to cluster administrators at the admin privilege level.

    Description

    The system controller location-led modify command modifies the current state of the location LED. When lit, the location LED can help you find the controller in the data center.

    There is a blue location LED on every controller and on the front of the chassis. When you turn on the location LED for either controller, the chassis location LED automatically turns on. When both controller location LEDs are off, the chassis location LED automatically turns off.

    After the location LED is turned on, it stays illuminated for 30 minutes and then automatically shuts off.

    Parameters

    -node {<nodename>|local} - Node

    Selects the location LED on the specified filers.

    [-state {on|off}] - LED State

    Modifies the state of the location LED on the filer.

    Examples

    The following example turns on the location LED:

    cluster1::*> system controller location-led modify -node node1 -state on

    Turn off Location LED.

    cluster1::*> system controller location-led modify -node node1 -state off
    Top of Page