ONTAP 9.12.1 commands

50←PDF
  • ONTAP 9.12.1 commands(CA08871-263en.pdf)
  • vserver fpolicy engine-disconnect

    Terminate connection to FPolicy server

    Availability: This command is available to cluster and Vserver administrators at the admin privilege level.

    Description

    The vserver fpolicy engine-disconnect command disconnects an FPolicy server from a specified node.

    Parameters

    -node {<nodename>|local} - Node

    This parameter specifies the node that you want to disconnect from the FPolicy server. The value local specifies the current node.

    -vserver <Vserver Name> - Vserver

    This parameter specifies the Vserver that you want to disconnect from the specified FPolicy server with the specified attached FPolicy policy.

    -policy-name <Policy name> - Policy

    This parameter specifies the name of the FPolicy policy that is attached with an external engine.

    -server <IP Address> - Server

    This parameter specifies the FPolicy server you want to disconnect. The specified server must be present in the external engine configuration of the above specified FPolicy policy.

    Examples

    The following example disconnects an FPolicy server.

    cluster1::> vserver fpolicy engine-disconnect -node FPolicy-01 -vserver vs1.example.com -policy-name p -server 1.1.1.1
    cluster1::> vserver fpolicy show
     FPolicy                                                      Server-        Server-
     Vserver         Policy        Node         Server            status         type
     --------------- ------------- ------------ ----------------- -------------- -----------
     vs1.example.com p             FPolicy-01   1.1.1.1           disconnected   primary
    Top of Page