ONTAP 9.12.1 commands

50←PDF
  • ONTAP 9.12.1 commands(CA08871-263en.pdf)
  • vserver peer reject

    Reject a Vserver peer relationship

    Availability: This command is available to cluster administrators at the admin privilege level.

    Description

    The vserver peer reject command is used to reject the Vserver peer relationship between the two Vservers. This command is used only for an intercluster Vserver peer relationship.

    Parameters

    -vserver <vserver> - Vserver Name

    Specifies the name of the local Vserver for which you want to reject the Vserver peer relationship.

    -peer-vserver <vserver> - Peer Vserver Name

    Specifies the name of the peer Vserver with which the Vserver peer relationship was initiated.

    Examples

    The following example illustrates how to reject the Vserver peer relationship between two Vservers lvs1.example.com residing on cluster1 , and pvs1.example.com residing on cluster2 .

    cluster1::> vserver peer reject -vserver lvs1.example.com -peer-vserver pvs1.example.com
    Top of Page