ONTAP 9.12.1 commands

50←PDF
  • ONTAP 9.12.1 commands(CA08871-263en.pdf)
  • network arp active-entry delete

    Delete active ARP entry from a System or Admin Vserver

    Availability: This command is available to cluster administrators at the advanced privilege level.

    Description

    The network arp active-entry delete command deletes dynamically learned ARP entries from the network stack of a node. To delete statically configured ARP entries use the network arp delete command.

    Parameters

    -node {<nodename>|local} - Node

    Use this parameter to specify the name of the node in which the ARP entry is deleted.

    -vserver <vserver> - System or Admin Vserver Name

    Use this parameter to specify the name of the Vserver in which the ARP entry is deleted. Only Vservers with a type of Admin or System have dynamically learned ARP entries.

    -subnet-group <IP Address/Mask> - Subnet Group Name

    Use this parameter to specify the name of the routing group in which the ARP entry is deleted.

    -remotehost <text> - Remote IP Address

    Use this parameter to specify the IP address to be deleted from the active ARP entries.

    -port <text> - Port

    Use this parameter to specify the name of the Port to be deleted from the active ARP entries.

    Examples

    The following example deletes the active ARP entry with an IP address of 10.224.64.1, subnet group of 0.0.0.0/0, port e0c on node node2 in the Admin Vserver cluster1:

    cluster1::*> network arp active-entry delete -node cluster1-01 -vserver cluster1 -subnet-group 0.0.0.0/0 -remotehost 10.224.64.1 -port e0c
    Top of Page