SANtricity 11.8 Commands ( CA08871-194 ~ 196 )

Show drive download progress

The show allDrives downloadProgress command returns the status of firmware downloads for the drives that are targeted by the download drive firmware command or the download storageArray driveFirmware command.

Supported Series

This command applies to any individual storage system, including the HB2100/HB2200/HB2300, HB5100/HB5200, AB6100 and AB3100 series, as long as all SMcli packages are installed.

Roles

To execute this command on an HB2100/HB2200/HB2300, HB5100/HB5200, AB6100, or AB3100 storage system, you must have the Storage Admin role.

Syntax

show allDrives downloadProgress

Parameters

None.

Notes

When all of the firmware downloads have successfully completed, this command returns good status. If any firmware downloads fail, this command shows the firmware download status of each drive that was targeted. This command returns the statuses shown in this table.

Status Definition

Successful

The downloads completed without errors.

Not Attempted

The downloads did not start.

Partial Download

The downloads are in progress.

Failed

The downloads completed with errors.

Top of Page