SANtricity 11.8 Commands ( CA08871-194 ~ 196 )

Start storage Array iSNS server refresh

The start storageArray isnsServerRefresh command initiates a refresh of the network address information for the iSNS server.

Supported Series

This command applies to any individual storage system, including the HB2100/HB2200/HB2300, HB5100/HB5200, AB6100 and AB3100 series, as long as all SMcli packages are installed.

Roles

To execute this command on an HB2100/HB2200/HB2300, HB5100/HB5200, AB6100, or AB3100 storage system, you must have the Storage Admin role.

Context

If the DHCP server is marginal or unresponsive, the refresh operation can take from two to three minutes to complete.

This command is for IPv4 only.

Syntax

start storageArray isnsServerRefresh

Parameter

None.

Notes

If you used the set storageArray isnsIPv4ConfigurationMethod command to set the configuration but did not set the configuration to DHCP, running the start storageArray isnsServerRefresh returns an error.

Top of Page