SANtricity 11.9 Commands ( CA08871-194 ~ 196 )

Stop check volume parity job

The stop check volume parity job command stops an in-progress check volume parity job.

Supported Series

This command applies to any individual storage system, including the ETERNUS AB3100 and ETERNUS AB6100; as long as all SMcli packages are installed.

Roles

To execute this command on an ETERNUS AB3100 and ETERNUS AB6100 storage system, you must have the Storage Admin role.

Syntax

stop check volume parity job jobId=<job_id>;

Parameters

Parameter Description

jobId

The job id corresponding to the check volume parity job to stop. This value is required.

Minimum firmware level

11.80

Top of Page