SANtricity 11.8 Commands ( CA08871-194 ~ 196 )

Enable or disable host connectivity reporting

The set storageArray hostConnectivityReporting command enables or disables host connectivity reporting on the controller.

Supported Series

This command applies to an individual HB2100/HB2200/HB2300, HB5100/HB5200, AB6100, or AB3100 storage system.

Roles

To execute this command on an HB2100/HB2200/HB2300, HB5100/HB5200, AB6100, or AB3100 storage system, you must have the Storage Admin role.

Syntax

set storageArray hostConnectivityReporting (enable | disable)

Context

When you enable host connectivity reporting on the storage system, the storage system continuously monitors the connection between the storage system’s controllers and the configured hosts and alerts you if the connection is disrupted due to a loose, damaged, or missing cable or other problems with the host. You are also notified if the host type is incorrectly specified on the storage system (which could result in failover problems).

To disable host connectivity reporting, you must first disable automatic load balancing.

You can keep host connectivity reporting enabled if automatic load balancing is disabled.

Host connectivity reporting and automatic load balancing function only on the Linux DHALUA, Windows/Windows Clustered, and VMware host types.

Parameters

None.

Top of Page