SANtricity 11.9 Commands ( CA08871-194 ~ 196 )

Reset storage system SOC baseline

The reset storageArray SOCBaseline command resets the baseline for all switch-on-a-chip (SOC) devices that are accessed through the controllers.

Supported Series

This command applies to any individual storage system, including the ETERNUS AB/HB series as long as all SMcli packages are installed.

Roles

To execute this command on the ETERNUS AB/HB series storage system, you must have the Storage Admin role.

Context

This command resets the baseline by setting all of the SOC counts to 0. This command is valid only for Fibre Channel devices in an arbitrated loop topology.

Syntax

reset storageArray SOCBaseline

Parameters

None.

Top of Page