SANtricity 11.9 Commands ( CA08871-194 ~ 196 )

Start SSD cache locate

The start ssdCache locate command identifies the Solid State Disks (SSDs) that are logically grouped together to form the SSD cache by blinking the indicator lights on the SSDs.

Supported Series

This command applies to any individual storage system, including the ETERNUS AB/HB series as long as all SMcli packages are installed.

Roles

To execute this command on the ETERNUS AB/HB series storage system, you must have the Support Admin role.

Context

Use the stop ssdCache locate command to turn off the indicator lights on the drives.

Syntax

start ssdCache [ssdCacheName] locate

Parameters

Parameter Description

ssdCache

The name of the SSD cache that you want to locate. Enclose the SSD cache name in square brackets ([ ]). If the SSD cache name contains special characters or consists only of numbers, you must enclose the SSD cache name in double quotation marks (" ") inside square brackets.

Minimum firmware level

11.80 adds ETERNUS AB3100 and ETERNUS AB6100 support

Top of Page