SANtricity 11.9 Commands ( CA08871-194 ~ 196 )

Start synchronous mirroring synchronization

The start syncMirror primary synchronize command starts synchronous mirroring synchronization.

Supported Series

This command applies to any individual storage system, including the ETERNUS HB1100/HB1200, ETERNUS HB2100/HB2200/HB2300 and ETERNUS HB5100/HB5200 series, as long as all SMcli packages are installed.

Roles

To execute this command on an ETERNUS HB1100/HB1200, ETERNUS HB2100/HB2200/HB2300 or ETERNUS HB5100/HB5200 storage system, you must have the Storage Admin role.

Context

In previous versions of this command the feature identifier was remoteMirror. This feature identifier is no longer valid and is replaced by syncMirror.

Syntax

start syncMirror primary ["volumeName"] synchronize

Parameter

Parameter Description

primary

The name of the primary volume for which you want to start synchronization. Enclose the primary volume name in double quotation marks (" ") inside of square brackets ([ ]).

Minimum firmware level

11.80 adds ETERNUS AB6100 and ETERNUS AB3100 series support

Top of Page