SANtricity 11.8 Commands

to Japanese version

Register SNMP trap destination

The create snmpTrapDestination command creates a new Simple Network Management Protocol (SNMP) trap destination. A trap destination is the SNMP manager to receive the trap messages.

Supported Series

This command applies to an individual HB2100/HB2200/HB2300, HB5100/HB5200, AB6100 or AB3100 storage system.

Roles

To execute this command on an HB2100/HB2200/HB2300, HB5100/HB5200, AB6100, or AB3100 storage system, you must have the Storage Admin or Support Admin role.

Syntax

create snmpTrapDestination trapReceiverIP=ipAddress
    (communityName="communityName" | (userName="userName" [engineId=(local | engineId)]))
    [sendAuthenticationFailureTraps=(TRUE | FALSE)]

Parameters

Parameter Description

trapReceiverIP

The IP address of the SNMP manager to which you want to send trap messages.

communityName

The name of the SNMP community for which you want to send trap messages.

userName

The name of the SNMP user for which you want to send trap messages.

engineId

The engine ID of the SNMP user for which you want to send trap messages. The engine ID is required if there is more than one USM user with the same user name. The value may be "local" to specify the local SNMP agent is the authoritative agent or a hexidecimal digit string to specify a remote SNMP agent engine ID.

sendAuthenticationFailureTraps

This parameter turns on or turns off sending authentication failure messages to an SNMP manager. To send authentication failure messages, set the parameter to TRUE. To prevent sending authentication failure messages, set the parameter to FALSE. The default is TRUE.

Top of Page