SANtricity 11.9 Commands ( CA08871-194 ~ 196 )

Start asynchronous mirroring synchronization

The start asyncMirrorGroup synchronize command starts Asynchronous Mirroring synchronization.

Supported Series

This command applies to any individual storage system, including the ETERNUS AB/HB series as long as all SMcli packages are installed.

Roles

To execute this command on the ETERNUS AB/HB series storage system, you must have the Storage Admin role.

Syntax

start asyncMirrorGroup ["asyncMirrorGroupName"] synchronize [deleteRecoveryPointIfNecessary]

Parameter

Parameter Description

asyncMirrorGroup

The name of the asynchronous mirror group for which you want to start synchronization. Enclose the asynchronous mirror group name in double quotation marks (" ") inside square brackets ([" "]).

deleteRecoveryPointIfNecessary

The parameter to delete the recovery point if the recoverable synchronization data has exceeded time threshold for recovery. Recovery point age is measured from the time the data was frozen on the primary storage system.

Minimum firmware level

8.60 adds the deleteRecoveryPointIfNecessary parameter. 11.80 adds ETERNUS AB3100 and ETERNUS AB6100 support

Top of Page