ONTAP 9.14.1 commands

metrocluster configuration-settings calibration show

Display the calibration measurements for local nodes in MetroCluster over IP configuration

Availability: This command is available to cluster administrators at the admin privilege level.

Description

The metrocluster configuration-settings calibration show command shows the bandwidth and latency between local and remote nodes in a MetroCluster over IP configuration.

Parameters

{ [-fields <fieldname>,…​]

If you specify the -fields <fieldname>, …​ parameter, the command output also includes the specified field or fields. You can use '-fields ?' to display the fields to specify.

| [-instance ] }

If you specify the -instance parameter, the command displays detailed information about all fields.

[-calibration-id <integer>] - Calibration ID

This field specifies Calibration ID.

[-subnet <IP Address>] - IP Subnet

This field specifies subnet.

[-node-uuid <UUID>] - Node UUID

This field specifies UUID of the node.

[-home-port {<netport>|<ifgrp>}] - Home Port

This field specifies name of the port used to measure latency and bandwidth.

[-node {<nodename>|local}] - Node Name

This field specifies name of the node.

[-collection-time <MM/DD/YYYY HH:MM:SS>] - Collection Time of Sample

This field specifies collection time of sample.

[-source-address <IP Address>] - Source Network Address

This field specifies IP address of the port on the node.

[-destination-address <IP Address>] - Destination Network Address

This field specifies IP address of the port on the partner node.

[-latency <double>] - Latency in ms

This field specifies latency in ms.

[-bandwidth <double>] - Bandwidth in Mb/s

This field specifies bandwidth in Mb/s.

[-num-packets-retransmitted <integer>] - Number of Packets Retransmitted

This field specifies the number of TCP packets retransmitted during bandwidth measurement.

[-pct-pkt-retrans <double>] - Percentage of packages retransmitted

This field specifies the percent of TCP packets retransmitted during bandwidth measurement.

Examples

The following example shows the output for the calibration show command in MetroCluster over IP configurations:
clusA::*> metrocluster configuration-settings calibration show
                                   Home Latency Bandwidth
  ID Subnet         Node     Port (ms)    (Mb/s)    Collection Time
  -- -------------- ---------------- ---- ------- --------- -------------------
  1  172.21.96.0    A1
                                   e0f  0.341   764       8/6/2019 16:20:07
                                   e0g  0.311   629       8/6/2019 16:20:22
        A2
                                   e0f  0.307   1265      8/6/2019 16:20:36
                                   e0g  0.307   1063      8/6/2019 16:20:50
  4 entries were displayed.
Top of Page