ONTAP 9.14.1 commands

network bgp config modify

Modify BGP configuration

Availability: This command is available to cluster administrators at the advanced privilege level.


The network bgp config modify command is used to modify a node’s border gateway protocol (BGP) configuration.


-node {<nodename>|local} - Node

This parameter specifies the node on which BGP configuration will be modified.

[-asn <integer>] - Autonomous System Number

This parameter specifies the autonomous system number (ASN). The ASN attribute is a positive integer of the range from 1 to 4,294,967,295. It should typically be chosen from RFC6996 "Autonomous System (AS) Reservation for Private Use" or the AS number assigned to the operator’s organization.

[-hold-time <integer>] - Hold Time

This parameter specifies the hold time in seconds.

[-router-id <IP Address>] - Router ID

This parameter specifies the local router ID. The router-id value takes the form of an IPv4 address.


cluster1::> network bgp config modify -node node1 -router-id -asn 20
Top of Page