ONTAP 9.14.1 commands

vserver fpolicy engine-disconnect

Terminate connection to FPolicy server

Availability: This command is available to cluster and Vserver administrators at the admin privilege level.


The vserver fpolicy engine-disconnect command disconnects an FPolicy server from a specified node.


-node {<nodename>|local} - Node

This parameter specifies the node that you want to disconnect from the FPolicy server. The value local specifies the current node.

-vserver <Vserver Name> - Vserver

This parameter specifies the Vserver that you want to disconnect from the specified FPolicy server with the specified attached FPolicy policy.

-policy-name <Policy name> - Policy

This parameter specifies the name of the FPolicy policy that is attached with an external engine.

-server <IP Address> - Server

This parameter specifies the FPolicy server you want to disconnect. The specified server must be present in the external engine configuration of the above specified FPolicy policy.


The following example disconnects an FPolicy server.

cluster1::> vserver fpolicy engine-disconnect -node FPolicy-01 -vserver vs1.example.com -policy-name p -server
cluster1::> vserver fpolicy show
 FPolicy                                                      Server-        Server-
 Vserver         Policy        Node         Server            status         type
 --------------- ------------- ------------ ----------------- -------------- -----------
 vs1.example.com p             FPolicy-01           disconnected   primary
Top of Page