ONTAP 9.14.1 commands

network ndp neighbor create

Create a static NDP neighbor entry

Availability: This command is available to cluster and Vserver administrators at the advanced privilege level.

Description

The network ndp neighbor create command creates a static Neighbor Discovery Protocol (NDP) neighbor entry within a Vserver.

Parameters

-vserver <vserver name> - Vserver Name

Use this parameter to specify the Vserver on which the NDP neighbor is to be created.

-neighbor <IP Address> - Neighbor Address

Use this parameter to specify the neighbor’s IPv6 address.

-mac-address <MAC Address> - MAC Address

Use this parameter to specify the neighbor’s MAC address.

Examples

The following example creates a NDP neighbor entry within Vserver vs0.

cluster1::*> network ndp neighbor create -vserver vs0 -neighbor 20:20::20 -mac-address 10:10:10:0:0:1
Top of Page