ONTAP 9.14.1 commands

system bridge modify

Modify a bridge’s configuration information

Availability: This command is available to cluster administrators at the admin privilege level.


The system bridge modify enables you to modify certain parameters for identifying and accessing the FC-to-SAS bridges added for monitoring in a MetroCluster configuration.


-name <text> - Bridge Name

This parameter specifies the name of the bridge.

[-address <IP Address>] - Bridge IP Address

This parameter specifies the IP address of the bridge.

[-snmp-community <text>] - SNMP Community Set on the Bridge

This parameter specifies the SNMP community set on the bridge.

[-managed-by {SNMP|in-band}] - Bridge Management Method

This parameter specifies whether the bridge uses the SNMP or in-band management method. FibreBridge 6500N uses SNMP only; FibreBridge 7500N may use either.

[-node-visible-list <text>,…​] - Nodes Bridge is Visble To

This parameter specifies bridges that are visible to the node.


The following command modifies 'ATTO_10.226.197.16' bridge SNMP community to 'public':

cluster1::> system bridge modify -name ATTO_10.226.197.16 -address -snmp-community public
Top of Page