ONTAP 9.14.1 commands

vserver services name-service ldap modify

Modify an LDAP configuration

Availability: This command is available to cluster and Vserver administrators at the admin privilege level.


The vserver services name-service ldap modify command modifies an LDAP client configuration’s association with a Vserver.

Make sure that you remove 'ldap' from the Vserver’s -ns-switch and -nm-switch configurations and test connectivity before disabling a working LDAP configuration.


-vserver <Vserver Name> - Vserver

This parameter specifies the Vserver with which you want to associate the LDAP client configuration. A data Vserver or admin Vserver can be specified.

[-client-config <text>] - LDAP Client Configuration

This parameter specifies the name of the LDAP client configuration, defined under vserver services name-service ldap client command, that you want to associate with the Vserver. The value of the bind-as-cifs-server parameter on this LDAP client should be false if the CIFS server of the associated data Vserver does not exist or exists in workgroup mode.

[-skip-config-validation <true>] - Skip Configuration Validation

Use this parameter to skip the LDAP configuration validation.

The LDAP client configuration, specified by the -client-config parameter, that you want to associate with the Vserver is validated to verify that at least one of the LDAP servers is reachable, and is providing LDAP services.


The validation fails if ONTAP was unable to connect to any LDAP server with the specified -client-config .


The following example modifies the LDAP client configuration used by Vserver "vs1" to "corpnew":

cluster1::> vserver services name-service ldap modify -vserver vs1 -client-config corpnew
Top of Page