ONTAP 9.14.1 commands

system switch fibre-channel refresh

Refresh back-end fibre-channel switch info

Availability: This command is available to cluster administrators at the advanced privilege level.


The system switch fibre-channel refresh command triggers a refresh of the SNMP data for the MetroCluster fibre-channel (FC) switches and FC-to-SAS bridges. It does not do anything if the refresh is already going on. The FC switches and FC-to-SAS bridges must have been previously added for monitoring by using the system switch fibre-channel add and system bridge add commands, respectively.


The following command triggers a refresh for the FC switch and FC-to-SAS bridge data:

cluster1::*> system switch fibre-channel refresh
Top of Page