ONTAP 9.14.1 commands

redo

Execute a previous command

Availability: This command is available to cluster and Vserver administrators at the admin privilege level.

Description

The redo command re-executes a command that has been executed previously in the current CLI session. Specify a previously run command using:

  • A string that matches part of a previous command. For example, if the only volume command you have run is volume show , enter redo``vol to re-execute the command.

  • The numeric ID of a previous command, as listed by the history command. For example, enter redo``4 to re-execute the fourth command in the history list.

  • A negative offset from the end of the history list. For example, enter redo`-2` to re-execute the command that you ran two commands ago.

Parameters

[<text>] - String, Event Number, or Negative Offset

Use this parameter to specify a string, a numeric ID from the command history, or a negative number that identifies the command to be re-executed.

Examples

The following example re-executes command number 10 in the command history:

cluster1::> redo 10
Top of Page