ONTAP 9.14.1 commands

network ndp default-router show

Display default routers

Availability: This command is available to cluster administrators at the advanced privilege level.

Description

The network ndp default-router show command displays Neighbor Discovery Protocol (NDP) default routers learned on a specified port.

Parameters

{ [-fields <fieldname>,…​]

If you specify the -fields <fieldname>, …​ parameter, the command output also includes the specified field or fields. You can use '-fields ?' to display the fields to specify.

| [-instance ] }

If you specify the -instance parameter, the command displays detailed information about all fields.

[-node {<nodename>|local}] - Node

Displays the NDP default routers from the specified node.

[-ipspace <IPspace>] - IPspace name

Displays the NDP default routers from the specified IPspace.

[-port {<netport>|<ifgrp>}] - Port

Displays the NDP default routers from the specified port.

[-router-addr <IP Address>] - Router Address

Displays the default routers that have the specified IPv6 addresses.

[-flag {none|managed-address-DHCPv6|other-DHCPv6}] - Flag

Displays the default routers that have the specified flag. The flag indicates whether addresses are available via DHCPv6 or other configuration information is available via DHCPv6.

[-expire-time {[<integer>d][<integer>h][<integer>m][<integer>s]|never|expired}] - Expire Time

Displays the default routers that have the specified expire time.

Examples

The following example displays NDP default routers on local port e0f.

cluster1::*> network ndp default-router show -port e0f -node local

Node: node1
IPspace: Default
Port     Router Address             Flag            Expire Time
-------- -------------------------- --------------  --------------
e0f      fe80::5:73ff:fea0:107      none            0d0h23m9s
Top of Page