ONTAP 9.14.1 commands

snapmirror config-replication status show

Display SnapMirror configuration replication status information

Availability: This command is available to cluster administrators at the admin privilege level.

Description

The snapmirror config-replication status show command displays the current SnapMirror configuration replication status.

The command displays the following aspects of SnapMirror configuration replication:

  • Enabled: Verifies that SnapMirror configuration replication is enabled on the cluster.

  • Running: Verifies that SnapMirror configuration replication is running on the cluster.

  • Storage Status: Verifies that SnapMirror configuration replication storage is healthy.

  • Storage In Use: Prints the location of SnapMirror configuration replication storage.

  • Storage Remarks: Prints the underlying root cause for non-healthy SnapMirror configuration storage.

  • Vserver Streams: Verifies that SnapMirror configuration replication Vserver streams are healthy.

Additional information about the warnings (if any) and recovery steps can be viewed by running the command with the -instance option.

Parameters

[-instance ]

If you specify the -instance parameter, the command displays detailed information about all fields.

Examples

The following example shows the execution of the command:

clus1::*> snapmirror config-replication status show
                Enabled: true
                Running: true
         Storage Status: ok
         Storage In Use: Cluster-wide Volume: MDV_CRS_3d47e9106b7d11e4a77b000c29f810a2_A
        Storage Remarks: -
        Vserver Streams: ok
Top of Page