ONTAP 9

to Japanese version

Set the privilege level in the CLI

You can set the privilege level in the CLI by using the set command. Changes to privilege level settings apply only to the session you are in. They are not persistent across sessions.

Steps
  1. To set the privilege level in the CLI, use the set command with the -privilege parameter.

Example of setting the privilege level

The following example sets the privilege level to advanced and then to admin:

cluster1::> set -privilege advanced
Warning: These advanced commands are potentially dangerous; use them only when directed to do so by Fujitsu personnel.
Do you wish to continue? (y or n): y
cluster1::*> set -privilege admin
Top of Page