ONTAP 9.14

to Japanese version

Set up NAS path failover with the CLI (ONTAP 9.7)

This workflow guides you through the networking configuration steps to set up NAS path failover for ONTAP 9.7. This workflow assumes the following:

  • You want to use NAS path failover best practices that simplify network configuration.

  • You want to use the CLI, not ONTAP System Manager.

  • You are configuring networking on a new system running ONTAP 9.7.

If you are running an ONTAP release later than 9.7, you should use the NAS path failover procedure for ONTAP 9.8 or later:

If you want details about network components and management, you should use the network management reference material:

Top of Page