ONTAP 9

to Japanese version

Create a FlexClone file or FlexClone LUN

You can create space-efficient and time-efficient clones of files and LUNs present in FlexVol volumes or FlexClone volumes by using the volume file clone create command.

What you’ll need
  • The FlexClone license must be installed on the cluster.

  • If multiple block ranges are used for sub-LUN cloning or sub-file cloning, the block numbers must not overlap.

  • If you are creating a sub-LUN or sub-file on volumes with adaptive compression enabled, the block ranges must not be misaligned.

    This means that the source start block number and destination start block number must either be even aligned or odd aligned.

About this task

Depending on the privileges assigned by the cluster administrator, an SVM administrator can create FlexClone files and FlexClone LUNs.

You can specify the autodelete setting for FlexClone files and FlexClone LUNs when you create and modify clones. By default, the autodelete setting is disabled.

You can overwrite an existing FlexClone file or FlexClone LUN when you create a clone by using the volume file clone create command with the -overwrite-destination parameter.

When the node reaches its maximum split load, the node temporarily stops accepting requests to create FlexClone files and FlexClone LUNs and issues an EBUSY error message. When the split load for the node falls below the maximum, the node accepts requests to create FlexClone files and FlexClone LUNs again. You should wait until the node has capacity to create the clones before trying the create request again.

Steps
  1. Create a FlexClone file or FlexClone LUN by using the volume file clone create command.

    The following example shows how you can create a FlexClone file file1_clone of the parent file file1_source in the volume vol1:

    cluster1::> volume file clone create -vserver vs0 -volume vol1 -source-path /file1_source -destination-path /file1_clone

    For more information about using this command, see the man pages.

Related information

ONTAP 9 commands

Top of Page