If your security setup requires you to use different keys for data authentication and FIPS 140-2 authentication, you should create a separate key for each. If that’s not the case, you can use the same authentication key for FIPS compliance that you use for data access.

ONTAP creates authentication keys for all nodes in the cluster.

This command is not supported when Onboard Key Manager is enabled. However, two authentication keys are created automatically when Onboard Key Manager is enabled. The keys can be viewed with the following command:

security key-manager key query -key-type NSE-AK
You receive a warning if the configured key management servers are already storing more than 128 authentication keys.

You can use the security key-manager key delete command to delete any unused keys. The security key-manager key delete command fails if the given key is currently in use by ONTAP. (You must have privileges greater than “admin” to use this command.)

In a MetroCluster environment, before you delete a key, you must make sure that the key is not in use on the partner cluster. You can use the following commands on the partner cluster to check that the key is not in use:

storage encryption disk show -data-key-id key-id
storage encryption disk show -fips-key-id key-id

Before you begin

You must be a cluster administrator to perform this task.

Steps

Create the authentication keys for cluster nodes:

security key-manager key create -key-tag passphrase_label -prompt-for-key true|false

Setting prompt-for-key=true causes the system to prompt the cluster administrator for the passphrase to use when authenticating encrypted drives. Otherwise, the system automatically generates a 32-byte passphrase. The security key-manager key create command replaces the security key-manager create-key command. For complete command syntax, see the man page.

The following example creates the authentication keys for cluster1, automatically generating a 32-byte passphrase:

cluster1::> security key-manager key create
Key ID: 000000000000000002000000000001006268333f870860128fbe17d393e5083b0000000000000000

Verify that the authentication keys have been created:

security key-manager key query -node node

The security key-manager key query command replaces the security key-manager query key command. For complete command syntax, see the man page. The key ID displayed in the output is an identifier used to refer to the authentication key. It is not the actual authentication key or the data encryption key.

The following example verifies that authentication keys have been created for cluster1:

cluster1::> security key-manager key query
       Vserver: cluster1
   Key Manager: external
          Node: node1

Key Tag                               Key Type  Restored
------------------------------------  --------  --------
node1                                 NSE-AK    yes
    Key ID: 000000000000000002000000000001000c11b3863f78c2273343d7ec5a67762e0000000000000000
node1                                 NSE-AK    yes
    Key ID: 000000000000000002000000000001006f4e2513353a674305872a4c9f3bf7970000000000000000

       Vserver: cluster1
   Key Manager: external
          Node: node2

Key Tag                               Key Type  Restored
------------------------------------  --------  --------
node2                                 NSE-AK    yes
    Key ID: 000000000000000002000000000001000c11b3863f78c2273343d7ec5a67762e0000000000000000
node2                                 NSE-AK    yes
    Key ID: 000000000000000002000000000001006f4e2513353a674305872a4c9f3bf7970000000000000000

ONTAP 9 Manuals ( CA08871-402 )

Create authentication keys in ONTAP 9.7 and later

On this page